1. TFTP 서버를 사용하는 경우
rommon 1 IP_ADDRESS=171.68.171.0
rommon 2 IP_SUBNET_MASK=255.255.254.0
rommon 3 DEFAULT_GATEWAY=171.68.170.3
rommon 4 TFTP_SERVER=171.69.1.129
rommon 5 TFTP_FILE=c2600 -is-mz.113 -2.0.3.Q
rommon 6 tftpdnld
IP_ADDRESS: 171.68.171.0
IP_SUBNET_MASK: 255.255.254.0
DEFAULT_GATEWAY: 171.68.170.3
TFTP_SERVER: 171.69.1.129
TFTP_FIL-is-mz.113-2.0.3.
Invoke this command for disaster recovery only.
WARNING: all existing data in all partitions on flash will be lost!
Do you wish to continue? y/n: y
Receiving c2-is-mz.113-2.0.3.Q from 171.69.1.129 !!!!!.!!!!!! !!!!!!!!!!!!.!!
File reception completed.
Copying file c-i-mz.113-2.0.3.Q to fla h.
Erasing flash at 0x607c0000
program flash location 0x60440000
rommon 7reset
2. Console 포트를 사용하는 경우
1.먼저 라우터에 Xmodem 포트 설정을 한다 .
rommon 1 > confreg
do you wish to change the configuration? y/n y]:
enable "diagnostic mode"? y/n n]:
enable "use net in IP bcast address"? y/n [n]:
disable "load rom after netboot fails"? y/n [n]:
enable "use all zero broadcast"? y/n [n]:
enable "break/abort has effect"? y/n [n]:
enable "ignore system config info"? y/n [n]:
change console baud rate? y/n [n] y
enter rate: 0 = 9600, 1 = 4800, 2 = 1200, 3 = 2400
4 = 19200, 5 = 38400, 6 = 57600, 7 = 75200 [7]:
change the boot characteristics? y/n [y]:
enter to boot:
0 = ROM Monitor
1 = the boot helper image
-15 = boot system
[0]: 0
Configuration Summary
enabled are:
load rom after netboot fails
console baud: 115200
boot: the ROM Monitor
do you wish to change the configuration? y/n [n]: n
You must reset or power cycle for new config to take effect
2. Xmodem 을 초기화 한다.
rommon 2 > xmodem -c c2600 -is-mz.122 -17.bin
Do not start the sending program yet...
File size Checksum File name
3.명령어를 입력한 다음
Terminal Client 프로그램에서 파일을 전송한다 .
'Network Default > Router' 카테고리의 다른 글
cisco 라우터 log 설정 (0) | 2010.11.25 |
---|---|
[Foundry] BigIron 15000 (0) | 2009.01.07 |
[Password Recovery] 2500 Serise (0) | 2008.12.31 |
[IOS upgrade] C2500 시리즈 (0) | 2008.12.31 |